Cryo and Blueprint Action

Single point cut receiver threads true & concentric to the bore center line.  True shoulder of receiver to the bore center line.  True bolt face.  True & lap receiver & bolt locking lugs mating the surfaces to insure 95% plus contact.  Hone and polish firing pin spring channel (reduces lock time). 

* Custom made oversized bolt (.7035” diameter, 15/10,000^th of an inch bolt to bolt raceway clearance) with Sako extractor, extended bolt handle, choice of firing pin/bolt shroud assemblies.  The bolt raceway is concentrically line bored to .705” diameter - add $350.00

* Remington 700 receiver sleeved (exterior sleeve increases outside diameter to 1.650")  add$600

*Bolt single sleeve - rear - add $100.00

*Bolt double sleeved - add $200.00

$300.00 

Blueprint Action

Same as above less the cryo treatment.  This is something that I feel very strongly about.  Without the cryo treatment the assembly is going to warp as it heats & cools.  At room temperature you will have the machined surfaces flush and square, but after it starts to heat, who knows where, and how far they will warp.

$175.00

Accurize Factory Production Rifle

Cut front receiver face, and receiver locking lugs true.  Cut back barrel shoulder .10" and true.   Re-crown and  hand lap barrel.  Re-chamber to minimum headspace.  Cut bolt locking lugs true & lap.  Cryo the action/barrel assembly.  Pillar bed and inlet the stock for stress free bedding.  Range test rifle accuracy.  Target is shipped with the rifle.

$1100.00 

11 Degree Crown

All crowns are piloted off of the bore  at both ends of the barrel, and not 1 but 2 test indicators used to center the bore in the lathe head stock and in the spider gear and are guaranteed to be concentric to at least 0001".  The technique that we use guarantees axial alignment.

$75.00

Step Crown

$75.00

Install Sako Style Extractor

Remington bolt

$135.00

Lap Barrel

Hand lap barrel

$135.00

Install Barrel

Remove old barrel.  Install Pre-threaded and pre-chambered barrel.  Check headspace.  If the barrel is one of the offerings that are either long or short chambered or for some reason won't headspace correctly they will require machine time at the hourly rate plus the flat rate charge.

$85.00

Check Headspace & Action Function

$50.00

Polish Chamber

 Removes flaws (scratches, galling, etc.)

$45.00

Make Chamber Cast

$45.00

Remove Barrel Fouling

Lead ,copper, and powder residue fouling

$45.00

Adjust & Stone 2 Stage Triggers

Adjust & stone trigger parts & sear

$75.00

Install After Market Trigger

Install and adjust to your specifications

$50.00

Install Scope Rings and Base(s)

Install on pre-drilled & tapped receiver.  Install scope rings and base(s) then ream for proper alignment.

$75.00

Ream Scope Rings

Aligns scope rings so that they are aligned with the bore, and scope is stress free.

$50.00

Drill & Tap Receiver for Scope or Iron Sights

Jig fixture used so holes are aligned & perpendicular

$25.00 per hole

Jewelling Damascening

Jewel bolt, trigger guard, etc.

$75.00/hr

Ream & Hone Firing Pin Channel

Remove machining flaws in firing pin channel to reduce lock time

$25.00

Pin Recoil Lug

Remington Actions

$75.00

Replace-Change Bolt Handle 

Parts not included

$100.00

3 Position Safety Bolt Shroud Assembly Installation

Parts not included

$150.00

Flute Bolt Body

Straight Flutes

$110.00

Flute Barrel

Straight Flutes

$200.00